application of Epoxy flooring to any Garage floor

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a place to park the autos and store the extra boxes of Xmas decorations and such. However, like any other room in your own home your storage area floor needs to be taken attention of.
Because of the put it to use gets, combined with water, gas and engine oil that will inescapable be spilled after it, garage floor can easily become destroyed and start to break apart over time useful. Epoxy coating is one means to fix your garage flooring challenge. Epoxy coating applies a level of sealant and protectant to your concrete car port floor to make it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor takes a little up-front preparation before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy covering onto is free from moisture, residual coloring and does not have a concrete sealer or other completing applied to it.
To check for moisture, have a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the plastic facing the floor. If moisture exists, than an epoxy floor coverings layer is not appropriate as epoxy requires a dry surface to properly bond with the flooring.
Next, we’ll test to ensure the flooring does not have a sealant already applied to it. This test will also check for the presence of natural oils in the concrete as well. Take a cup of drinking water and pour it immediately onto the prevailing flooring. It should soak into the floor in an acceptable amount of time. If it beads or just sits on top of the flooring then your floor has probably recently been sealed or has oil impurities. Epoxy flooring is not ideal for cement floors which may have already been covered or contain any type of petrol residue as you won’t bond.
Finally, if you are willing to spend several months testing a location of your storage area floor for suitability to setting up epoxy floor you can color a small area with regular, oil-based teeth enamel. If this test area can last for several months then chances are an epoxy layer will last as well. However, if you opt to proceed with applying the epoxy layer you will need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *