application of Epoxy flooring to a Garage surface

Often we don’t think about our garages or pay much attention to their appearance. They are merely a location to park the vehicles and store the extra boxes of Xmas decorations and such. However, like any other room in your house your storage floor needs to be taken health care of.
Due to the use it gets, combined with drinking water, gas and essential oil that will inescapable be spilled after it, garage floors can certainly become ruined and commence to fall apart after a few years of use. Epoxy finish is one method for your garage floors challenge. Epoxy layer applies a coating of sealant and protectant to your concrete car port floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors requires a little up-front planning before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy finish onto is free from moisture, residual car paint and does not have a concrete sealer or other completing applied to it.
To test for moisture, take a sheet of vinyl and take it to a 3-ft . x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the clear plastic facing the ground. If moisture exists, than an epoxy floor finish is not suited as epoxy needs a dry surface to properly bond with the floor.
Next, we’ll test to be sure the flooring does not have a sealant already put on it. This test will also check for the presence of oils in the concrete as well. Have a cup of normal water and pour it straight onto the prevailing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or simply sits on top of the flooring then the floor coverings has probably recently been sealed or has oil contaminants. Epoxy floor coverings is not suited to cement floors that have already been covered or contain any kind of essential oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing an area of your car port floor for suitability to installing epoxy floors you can color a tiny area with regular, oil-based teeth enamel. If this test area endures for several weeks then it is likely an epoxy finish can last as well. However, if you opt to proceed with making use of the epoxy coating you will need to eliminate this enamel covering which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *