application of Epoxy flooring to a Garage surface

Often we don’t think about our garages or pay much focus on the look of them. They are merely a destination to park the autos and store the excess boxes of Holiday accessories and such. However, like any other room in your house your garage floor needs to be taken attention of.
Due to the utilize it gets, coupled with drinking water, gas and essential oil that will unavoidable be spilled upon it, garage flooring can easily become broken and get started to fall apart after a few years of use. Epoxy covering is one treatment for your garage flooring challenge. Epoxy finish applies a level of sealant and protectant to your concrete storage area floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor requires a little up-front preparation before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy covering onto is free from moisture, residual car paint and doesn’t have a cement sealer or other finishing applied to it.
To test for moisture, take a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the plastic material facing the floor. If moisture exists, than an epoxy floor coating is not ideal as epoxy requires a dry out surface to properly relationship with the floors.
Next, we’ll test to be sure the flooring doesn’t have a sealant already put on it. This test will also check for the presence of oils in the cement as well. Take a cup of normal water and pour it directly onto the existing flooring. It should soak in to the floor in an acceptable timeframe. If it beads or perhaps sits on top of the flooring then your floor has probably recently been sealed or has oil contaminants. Epoxy floor coverings is not suited to cement floors which have already been sealed or contain any type of engine oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your storage area floor for suitability to setting up epoxy floor coverings you can coloring a tiny area with regular, oil-based teeth enamel. If this test area can last for several months then chances are an epoxy finish will last as well. However, if you decide to proceed with making use of the epoxy finish you’ll need to eliminate this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *