application of Epoxy flooring to a Garage floors

Many times we don’t think about our garages or pay much attention to the look of them. They are simply just a spot to park the cars and store the excess boxes of Xmas designs and such. However, like any other room in your own home your car port floor needs to be taken treatment of.
Because of the put it to use gets, coupled with normal water, gas and petrol that will inescapable be spilled upon it, garage flooring can simply become broken and start to break apart over time useful. Epoxy covering is one answer to your garage floors challenge. Epoxy covering applies a covering of sealant and protectant to your concrete car port floor to help it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front planning before beginning. The main step in the process is ensuring the floor you are going to apply the epoxy coating onto is free from moisture, residual paint and does not have a cement sealer or other finishing applied to it.
To test for moisture, take a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and then remove and check for any moisture collecting privately of the vinyl facing the ground. If moisture is present, than an epoxy floor coating is not ideal as epoxy requires a dried out surface to properly relationship with the flooring.
Next, we’ll test to be sure the flooring does not have a sealant already applied to it. This test will also look for the presence of natural oils in the concrete as well. Have a cup of normal water and put it directly onto the existing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or simply sits together with the flooring then the floor coverings has probably recently been sealed or contains oil pollutants. Epoxy floor is not well suited for cement floors which may have already been covered or contain any kind of engine oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing a location of your garage floor for suitability to installing epoxy flooring you can coloring a tiny area with regular, oil-based enamel. If this test area can last for several a few months then it is likely an epoxy finish will last as well. However, if you opt to proceed with applying the epoxy layer you will need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *