application of Epoxy flooring to a Garage Flooring

Many times we don’t think about our garages or pay much focus on the look of them. They are merely a place to park the vehicles and store the extra boxes of Xmas designs and such. However, like any other room in your house your storage floor must be taken care and attention of.
Because of the utilize it gets, combined with drinking water, gas and olive oil that will unavoidable be spilled after it, garage flooring can certainly become damaged and begin to fall apart over time useful. Epoxy coating is one way to your garage floor challenge. Epoxy covering applies a layer of sealant and protectant to your concrete garage area floor to make it resist staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The most important step in the procedure is ensuring the floor you are going to apply the epoxy covering onto is free of moisture, residual coloring and doesn’t have a concrete sealer or other finishing put on it.
To test for moisture, have a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and check for any moisture collecting privately of the plastic material facing the ground. If moisture exists, than an epoxy floors covering is not ideal as epoxy requires a dried surface to properly connection with the floor.
Next, we’ll test to be sure the flooring does not have a sealant already put on it. This test will also look for the presence of oils in the cement as well. Have a cup of normal water and put it straight onto the existing flooring. It will soak in to the floor in a reasonable timeframe. If it beads or simply sits on top of the flooring then the floors has probably recently been sealed or is made up of oil pollutants. Epoxy floor is not suitable for cement floors which may have already been covered or contain any kind of olive oil residue as you won’t bond.
Finally, if you are prepared to spend several months testing a location of your car port floor for suitability to putting in epoxy flooring you can color a small area with regular, oil-based teeth enamel. If this test area endures for several calendar months then it is likely an epoxy layer can last as well. However, if you decide to proceed with making use of the epoxy covering you’ll need to eliminate this enamel finish which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *