application of Epoxy Coatings to Your Garage surface

Many times we don’t believe about our garages or pay much attention to the look of them. They are simply just a place to park the cars and store the extra boxes of Xmas designs and such. However, like any other room in your house your car port floor needs to be taken treatment of.
Due to the use it gets, combined with water, gas and engine oil that will inevitable be spilled upon it, garage flooring can simply become damaged and get started to fall apart after a few years of use. Epoxy covering is one treatment for your garage flooring challenge. Epoxy finish applies a part of sealant and protectant to your concrete car port floor to make it withstand staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front preparation before beginning. The most important step in the procedure is ensuring the ground you are going to apply the epoxy covering onto is free from moisture, residual paint and doesn’t have a concrete sealer or other finishing put on it.
To check for moisture, have a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and look for any moisture collecting on the side of the plastic facing the ground. If moisture is present, than an epoxy floor covering is not ideal as epoxy needs a dried up surface to properly bond with the floor.
Next, we’ll test to make sure the flooring doesn’t have a sealant already put on it. This test will also check for the existence of natural oils in the concrete as well. Take a cup of normal water and pour it straight onto the prevailing flooring. It will soak into the floor in an acceptable amount of time. If it beads or perhaps sits on top of the flooring then the floors has probably recently been sealed or includes oil contaminants. Epoxy flooring is not ideal for cement floors which may have already been closed or contain any kind of olive oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your car port floor for suitability to putting in epoxy flooring you can paint a little area with regular, oil-based enamel. If this test area lasts for several weeks then chances are an epoxy finish will last as well. However, if you opt to proceed with making use of the epoxy layer you will need to remove this enamel coating that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *