application of Epoxy Coatings to Your Garage Flooring

Many times we don’t think about our garages or pay much attention to their appearance. They are merely a place to park the autos and store the excess boxes of Christmas accessories and such. However, like any other room in your house your garage area floor must be taken health care of.
Because of the utilize it gets, combined with drinking water, gas and engine oil that will inescapable be spilled upon it, garage floor coverings can easily become broken and commence to fall apart after a few years useful. Epoxy covering is one way to your garage flooring challenge. Epoxy layer applies a covering of sealant and protectant to your concrete car port floor to make it avoid staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor coverings requires a little up-front prep before beginning. The most important step in the procedure is making sure that the ground you are going to apply the epoxy covering onto is free of moisture, residual car paint and doesn’t have a cement sealer or other completing applied to it.
To check for moisture, have a sheet of plastic material and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the plastic material facing the floor. If moisture exists, than an epoxy flooring layer is not suited as epoxy needs a dry surface to properly relationship with the floor.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also check for the existence of natural oils in the concrete as well. Have a cup of drinking water and pour it immediately onto the existing flooring. It will soak in to the floor in an acceptable timeframe. If it beads or maybe sits on top of the flooring then your flooring has probably recently been sealed or has oil contaminants. Epoxy floor coverings is not suitable for cement floors that contain already been sealed or contain any type of oil residue as you won’t bond.
Finally, if you are willing to spend almost a year testing an area of your car port floor for suitability to installing epoxy flooring you can color a tiny area with regular, oil-based teeth enamel. If this test area is maintained for several weeks then chances are an epoxy coating can last as well. However, if you decide to proceed with making use of the epoxy layer you will need to remove this enamel coating which will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *