application of Epoxy Coatings to the Garage floors

Often we don’t believe about our garages or pay much attention to the look of them. They are merely a location to park the autos and store the excess boxes of Christmas accessories and such. However, like any other room in your own home your storage area floor needs to be taken good care of.
Because of the use it gets, combined with normal water, gas and olive oil that will inescapable be spilled upon it, garage floor can simply become destroyed and start to fall apart after a few years useful. Epoxy layer is one solution to your garage floor coverings challenge. Epoxy covering applies a part of sealant and protectant to your concrete garage floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floors requires a little up-front prep before beginning. The main step in the procedure is ensuring the ground you will apply the epoxy finish onto is free from moisture, residual car paint and doesn’t have a cement sealer or other completing put on it.
To test for moisture, have a sheet of plastic material and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two days and nights and then remove and look for any moisture collecting on the side of the vinyl facing the floor. If moisture exists, than an epoxy floor coverings covering is not suited as epoxy requires a dried up surface to properly bond with the floor coverings.
Next, we’ll test to make certain the flooring doesn’t have a sealant already applied to it. This test will also look for the existence of oils in the cement as well. Take a cup of water and put it straight onto the prevailing flooring. It will soak in to the floor in an acceptable amount of time. If it beads or simply sits on top of the flooring then your floor has probably already been sealed or is made up of oil contaminants. Epoxy floor is not ideal for cement floors which have already been closed or contain any type of essential oil residue as it will not bond.
Finally, if you are prepared to spend several months testing a location of your garage area floor for suitability to putting in epoxy floor coverings you can color a small area with regular, oil-based teeth enamel. If this test area will last for several calendar months then chances are an epoxy covering can last as well. However, if you decide to proceed with applying the epoxy layer you’ll need to remove this enamel layer that may require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *