application of Epoxy Coatings to any Garage Flooring

Many times we don’t think about our garages or pay much focus on their appearance. They are merely a destination to park the cars and store the extra boxes of Christmas adornments and such. However, like any other room in your house your storage floor must be taken health care of.
Due to the make use of it gets, combined with water, gas and essential oil that will inescapable be spilled upon it, garage floor can easily become damaged and start to break apart over time useful. Epoxy finish is one treatment for your garage flooring challenge. Epoxy covering applies a coating of sealant and protectant to your concrete storage area floor to make it avoid staining, moisture problems and helps it maintain its appearance.
Installing epoxy floor takes a little up-front planning before beginning. The most important step in the procedure is making sure that the floor you are going to apply the epoxy coating onto is free of moisture, residual color and does not have a cement sealer or other finishing put on it.
To test for moisture, take a sheet of vinyl and take it to a 3-feet x 3-foot area using masking tape. Keep it there for about two times and then remove and look for any moisture collecting privately of the vinyl facing the ground. If moisture is present, than an epoxy flooring covering is not suitable as epoxy needs a dried surface to properly bond with the floors.
Next, we’ll test to make sure the flooring does not have a sealant already put on it. This test will also check for the existence of natural oils in the cement as well. Have a cup of drinking water and put it immediately onto the prevailing flooring. It should soak into the floor in an acceptable timeframe. If it beads or maybe sits together with the flooring then your floors has probably recently been sealed or consists of oil impurities. Epoxy flooring is not suited to cement floors which have already been covered or contain any kind of engine oil residue as it will not bond.
Finally, if you are prepared to spend almost a year testing a location of your storage area floor for suitability to installing epoxy flooring you can color a little area with regular, oil-based teeth enamel. If this test area lasts for several weeks then chances are an epoxy layer will last as well. However, if you opt to proceed with applying the epoxy covering you’ll need to remove this enamel finish that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *