application of Epoxy Coatings to any Garage floor

Often we don’t believe about our garages or pay much focus on the look of them. They are simply just a spot to park the vehicles and store the extra boxes of Xmas adornments and such. However, like any other room in your house your garage area floor must be taken good care of.
Because of the use it gets, coupled with normal water, gas and oil that will unavoidable be spilled after it, garage flooring can certainly become ruined and start to fall apart after a few years useful. Epoxy layer is one answer to your garage floors challenge. Epoxy coating applies a part of sealant and protectant to your concrete storage floor to help it withstand staining, moisture problems and helps it maintain its appearance.
Installing epoxy floors takes a little up-front prep before beginning. The main step in the process is making sure that the floor you are going to apply the epoxy layer onto is free from moisture, residual paint and does not have a concrete sealer or other completing applied to it.
To check for moisture, take a sheet of clear plastic and take it to a 3-foot x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting on the side of the vinyl facing the floor. If moisture exists, than an epoxy floor coverings covering is not ideal as epoxy needs a dried surface to properly connection with the flooring.
Next, we’ll test to be sure the flooring does not have a sealant already applied to it. This test will also look for the occurrence of natural oils in the concrete as well. Have a cup of normal water and put it directly onto the existing flooring. It will soak into the floor in an acceptable amount of time. If it beads or simply sits on top of the flooring then the floor coverings has probably recently been sealed or contains oil impurities. Epoxy floors is not suited to cement floors which have already been closed or contain any kind of oil residue as you won’t bond.
Finally, if you are prepared to spend almost a year testing an area of your garage floor for suitability to putting in epoxy flooring you can coloring a small area with regular, oil-based teeth enamel. If this test area will last for several months then chances are an epoxy finish can last as well. However, if you decide to proceed with making use of the epoxy covering you will need to remove this enamel layer that will require sanding.

Leave a Reply

Your email address will not be published. Required fields are marked *