using Epoxy paint to a Garage surface

Often we don’t think about our garages or pay much focus on the look of them. They are simply just a place to park the automobiles and store the excess boxes of Christmas decor and such. However, like any other room in your own home your car port floor needs to be taken treatment of.
Due to the use it gets, coupled with drinking water, gas and oil that will inevitable be spilled after it, garage flooring can easily become ruined and begin to break apart after a few years useful. Epoxy covering is one treatment for your garage floor coverings challenge. Epoxy coating applies a level of sealant and protectant to your concrete car port floor to help it resist staining, moisture problems and helps it maintain steadily its appearance.
Installing epoxy floor requires a little up-front prep before beginning. The main step in the procedure is making sure that the floor you will apply the epoxy finish onto is free of moisture, residual color and does not have a cement sealer or other concluding applied to it.
To test for moisture, have a sheet of clear plastic and take it to a 3-feet x 3-foot area using masking tape. Keep it there for approximately two days and nights and then remove and check for any moisture collecting privately of the plastic facing the ground. If moisture is present, than an epoxy floor coverings covering is not suitable as epoxy requires a dried up surface to properly bond with the floors.
Next, we’ll test to make certain the flooring doesn’t have a sealant already put on it. This test will also check for the occurrence of natural oils in the concrete as well. Have a cup of drinking water and pour it directly onto the existing flooring. It should soak into the floor in a reasonable amount of time. If it beads or perhaps sits together with the flooring then your floor has probably recently been sealed or contains oil pollutants. Epoxy floor is not suited to cement floors that contain already been closed or contain any type of petrol residue as it will not bond.
Finally, if you are willing to spend almost a year testing a location of your car port floor for suitability to putting in epoxy floor coverings you can color a little area with regular, oil-based enamel. If this test area can last for several calendar months then it is likely an epoxy finish will last as well. However, if you opt to proceed with applying the epoxy covering you will need to eliminate this enamel covering which will require sanding.